Location depth of the towed array sensor on a submarine
Screen *1: the sub follows on depth of 100 meters with speed of 7 kts.
Saggings of towed array is not observed. The contact from the ship on bearing 44 degrees is observed.
The rule of towed set is considered so:
Akula Draft: = 9.34 m
Towed Array Pod: located at 6.3 m.
9.34 + 6.3 = 14.36 m. and +2 m (system constant) = ~ 16 meters above lowest point sub.
100 meters (current depth) - 16 meters = 84 meters current position sensor.
Screen *2: the depth of a layer - 139 meters Is submitted.
Screen *3: There was a reduction of speed of a sub up to 2 kts.
Immersing cable of towed array set up to depth of 138 meters. The sensor control is higher than a layer.
The signal on bearing 48 degrees still is present.
Screen *4: the sensor control was lowered below than depth of a layer - 142 meters. The signal of the surface ship on bearing 48 degrees, was lost. Now sensor control works under a layer.
=================================================
This situation, shows - if in mission there are ships, the situation of a sensor control under a layer is easy for determining.
However - if in the mission there are no presented surface ships, the player actually can not know - what depth he supervises - UNDER a LAYER or ABOVE a LAYER.
The new option - allows it to have.
We have brought in some randomised element of failure of this option. Sometimes, the player can not receive any data on depth of a sensor control.
Friends - any critics waiting.
