[HELP] DSRV RA 1.1
We are trying to setup a new mission with the use of DSRV between a typhoon (Red October) and a los angeles II flt (Dallas): we put Dallas alligned and behind some miles from the Red October, then we release the DSRV.
In our tests, releasing the DSRV from Dallas to Red October, we are experiencing two different behaviours: 1) usually the DSRV crash to the conning tower of Red October, sinking it 2) sometime the DSRV reach the Red October, sail beside it for a while and then return to Dallas I think the second behaviour should be the correct one: can you confirm? Someone of us was expecting to see the DSRV approaching and docking to the Red October, but I think this is not possible: can you confirm too? Any suggestion to avoid the DSRV crash to the conning tower of the Red October (initial deep of Dallas or Red October, speeds, particular conditions)? Thanks in advance for help. EDIT: after some tests, seems that the DSRV try to dock to the Typhoon in the same place where it docks to the 688, but on the Red October the conning tower is really rear on the hull than the 688, and the DSRV finally collides with it in the approaching phase. |
I might add that the DSRV doesn't work when you target the Types 212 (Italian and German variants) nor the Harushios or Collins. In these cases, the target subs just accelerate to 3 knots the moment the DSRV is launched from the 688. The DSRV is never able to hover over the subs.
On the ther hand it works perfectly when targeting the French Rubis class. |
DSRV
I tried it so that the DSRV approaches the Red October from the front. It kind of worked, the DSRV did not crash into the Red October conning tower, but it didnt dock either it stopped and lowered so it was almost docked but never made contact. It just hovered for a few minutes then headed back to &688 where it did dock. When hovering over the Red October it showed the same depth as the October.
|
Вложений: 1
All the subs i try to send the DSRV to end up like the screenshot provided. The dsrv doesnt really make contact with the target sub. It hovers over the deck and then after some minutes it heads for home where it docks. It acts like its docked but it isnt. If this was an objective game i would consider it as a completed mission. Other opinions?
|
You can never make the DRSV dock with the target sub.
The most you can get it to do is hover above the sail (more or less) for some minutes and then return to base. |
PJB, you got the point! ;)
Seems that the DSRV release and approaching works fine if made with the sending and target subs one in front of the other, and not from the rear of the target sub. We did some tests and I confirm that sending the DSRV from the front of target sub avoid the crash against the conning tower: tomorrow night we will play the scenario and I will post the result. Thanks for help and suggestion. |
Цитата:
(Thank to developers of DW) Therefore implemented this behavior most similar to the dock. Цитата:
(Thank to developers of DW) Rubis - nuclear sub and it not concern her and others nuclear subs. Цитата:
Try this corrected doctrine for RedOctober (and others): see post below |
Цитата:
Thanks Jaf. |
Цитата:
Is there any chance of you guys correcting this bug ? |
Вложений: 2
Цитата:
Цитата:
To correctly use of DSRV have established a special emergency (unmovable) subs in the section "civilian-> subwrecks" of mission editor (in next release of RA diesel wreck subs will be included). Application of DSRV on "living" AI-subs may cause malfunctioning, because "live" AI-subs in accordance with its doctrines can change speed depending on external factors. DSRV doctrine has been corrected (not last correction :) redownload, please: |
Часовой пояс GMT +4, время: 10:30. |
Red Rodgers official site. Powered by TraFFa. ©2000 - 2024, Red Rodgers
vBulletin Version 3.8.12 by vBS. Copyright ©2000 - 2024, Jelsoft Enterprises Ltd. Перевод: zCarot